When a single-phase sine current passes through the stator winding, the motor generates an alternating magnetic field. The strength and direction of this magnetic field vary sinusoidally over time, but remain fixed in spatial orientation. Therefore, it is also known as an alternating pulsating magnetic field. This alternating pulsating magnetic field can be decomposed into two rotating magnetic fields with the same speed and opposite rotation directions. When the rotor is stationary, these two rotating magnetic fields generate two equal and opposite torques in the rotor, resulting in zero synthesized torque and preventing the motor from rotating. When we use external force to rotate the motor in a certain direction (such as clockwise rotation), the cutting magnetic field lines between the rotor and the rotating magnetic field in the clockwise direction become smaller; The cutting magnetic field lines between the rotor and the counterclockwise rotating magnetic field increase in motion. In this way, the balance is broken, and the total electromagnetic torque generated by the rotor will no longer be zero, and the rotor will rotate in the direction of thrust.
To enable a single-phase motor to automatically rotate, we can add a starting winding to the stator. The starting winding is 90 degrees apart from the main winding in space, and a suitable capacitor should be connected in series with the starting winding to ensure that the current is approximately 90 degrees out of phase with the main winding, which is known as the phase separation principle. By passing two currents that are 90 degrees apart in time into two windings that are 90 degrees apart in space, a rotating magnetic field (two-phase) will be generated in space,
Under the action of this rotating magnetic field, the rotor can automatically start. After starting, when the speed reaches a certain level, a centrifugal switch or other automatic control device installed on the rotor is used to disconnect the starting winding. During normal operation, only the main winding works. Therefore, the starting winding can be designed for short-term operation. But there are many times when the starting winding is not turned on. We call this type of motor a single-phase motor. To change the direction of this motor, simply swap the terminals of the auxiliary winding.
Another method of generating a rotating magnetic field in a single-phase motor is called the pole covering method, also known as a single-phase pole covering motor. This type of motor stator is made into a convex pole type, with two poles and four poles available. Each magnetic pole has a small groove at 1/3 to 1/4 of the full pole surface, which divides the magnetic pole into two parts. A short-circuit copper ring is fitted on the small part, as if covering this part of the magnetic pole, so it is called a covered pole motor. The single-phase winding is installed on the entire magnetic pole, and the coils of each pole are connected in series. When connecting, the polarity generated must be arranged in sequence according to N, S, N, and S. When the stator winding is energized, a main magnetic flux is generated in the magnetic poles. According to Lenz's law, the main magnetic flux passing through the short-circuit copper ring generates an induced current in the copper ring that lags behind the main magnetic flux by 90 degrees in phase. The magnetic flux generated by this current also lags behind the main magnetic flux in phase, and its effect is equivalent to that of the starting winding of a capacitive motor, thereby generating a rotating magnetic field to make the motor rotate.
Jul 02, 2024
Leave a message
Working Principle Of Single-phase Motor
Send Inquiry




